Whenever I try to communicate with PLC, Error message appear "Communication Link to Adapter damaged". For example My PCI adapter contins only two LEDs (1- Power, 2- Active) while information in the manual describe different number of LEDs. Moreover ! Order Entry of hardware for which drivers should support, is same as that of printed on my own PCI adapter but the manual contains different infromation about PCI adapter of the same Order entry ID. Fully compatible with USB V1.1 and USB CDC V1.1 specifications 4.USB bus power supply, current consumption is about 50mA 5. Support USB/PPI programming software version: STEP7 Micro/WIN V3.2 and above 3. The problem is that readme file doesn't contain information about drivers support for 64-bit system. Support USB/PPI operating system: Windows2000/WindowsXP (WinNT4/95/98/Me/DOS is not supported) 2. zip folderġ-Snapshot of my USB to MPI Adapter 6ES7 972-OCB20-OXA0 PC Adapter V5.4Ģ-Snapshot of error about drivers detail before installing PC Adapter drivers downloaded from nbsp &caller=viewģ- Snapshot of message about drivers detail after installing drivers downloaded from above link.Īlthough downloaded drivers are successfully installed on my system. Second ! Plz have a look at files in attached. The driver control running in the computer simulates the USB interface of the computer into a traditional serial port (commonly known as the COM. It is a programming cable that provides serial connection and RS485 signal conversion and PPI protocol conversion via USB interface. First ! My Laptop Hardware & Software Specifications USB/PPI cable is suitable for the Siemens S7-200 full range of PLCs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |